Red & Black Control Cabinets

Red and black industrial control cabinet with window apertures and side cable entries
two-tone control cabinet production view, powder coating lineHow it's builtCoated, then assembled on the same floor it was cut on.
See it built

Control cabinets in two colours, with a curved front face, window apertures and side cable entries. The colour split is not a paint job applied afterwards; it is a masking sequence designed with the panel geometry, so the break line sits on a fold or an aperture edge instead of across a flat face.

Two colours means two passes, and the second pass is where it fails

A two-tone cabinet is coated twice. The first colour is applied and cured, the panel is masked, the second colour goes on, and the whole part is cured again. Every problem in this process lives in the second pass: the masking tape leaves a step at its edge, the second cure can overbake the first coat, and any pinhole in the mask shows the wrong colour under the top layer.

Put the break line on a feature

A colour break in the middle of a flat panel will always show, because the tape edge is a physical step in the film and light rakes across it. Put the break on a fold, a radius, an aperture edge or a joint between two panels and the eye reads it as structure rather than as a coating defect. On this body the split runs along the curved front face edge, where the geometry already creates a line.

Cure temperature for the second coat

Curing the second colour at the same temperature as the first overbakes the base layer, and an overbaked polyester powder yellows and loses impact resistance. The second cure runs lower and longer, which is a schedule decision made at the line, not a datasheet default.

Irregular apertures in a curved face

Round holes, rectangular openings and screen windows on a curved front panel all have to come off one flat development. Flatten the curve onto the blank, cut and form, and the apertures land where the drawing says on the finished curve. Cut the holes after forming and the spacing drifts with the radius.

Technical Specifications

MaterialSPCC cold-rolled steel
Thickness1.5 mm or 2.0 mm
SurfaceTwo-tone powder coat, red and black, custom RAL
ProtectionIP54
Front faceCurved, radius formed
AperturesRound holes, rectangular openings, screen windows
Cable entrySide entries, gland plates
MOQ20 pcs

Typical Applications

Related Products

Get a quote for Red & Black Control Cabinets

Tell us quantity, material and surface finish — we reply within 24 hours with price and lead time.